Main page
Recent changes
Web relay
New name
B
I
U
S
link
image
code
list
Show page
Syntax
This set only name (or note) for each relay seperatly. Name will be show in controll section. If set name as '''n/a''', this relay is not shown in control section. * '''Realy name''' name each relay * '''multi throw''' Freely programmable relay function - single pole, single throw / single pole, more throw. Turn off all relays with the same settings outside of the current switched. * '''Save relay settings''' restore the current settings after reboot (available DISABLE or RESTORE). If enable, this setting shown in controll page. [http://remoteqth.com/img/wiki-s-relay2.png] If Save relay settings enable, show save status in last column. [http://remoteqth.com/img/wiki-s-relay3.png] [http://remoteqth.com/img/wiki-gpio2.png|link=http://elinux.org/RPi_Low-level_peripherals|right] ! Relay installation Relays board connec to GPIO port on Raspberry Pi used 15 GPIO outputs - see picture right. * GPIO [pinouts|http://remoteqth.com/img/wiki-rpi-pinout.png] [source|http://www.pighixxx.com/2013/11/raspberry-pi-pinout/] ---- [n2n VPN << Prev|n2n VPN] | [Next >> Sensors|Sensors]
Password
Summary of changes