Single rotator unit enclosure

B I U S link image code list	Show page   Syntax
[https://remoteqth.com/img/wiki-rot-case-1.jpg] ❏ check components [https://remoteqth.com/img/wiki-rot-case-2.jpg] ❏ mount two screws on the front panel with lock nut ❏ remove disk and nut on rotary encoder - they will not used/need ❏ '''shorten axis''' encoder about 5mm, '''if it is too long''' [https://remoteqth.com/img/wiki-rot-case-3.jpg] ❏ two spacers to the rear bottom side of the interface PCB and two screw the nut [https://remoteqth.com/img/wiki-rot-case-4.jpg] ❏ interface to put into the case and '''lightly tighten''' the two screws ''- smaller holes in the LCD may require two drilled out on 3mm holes.'' [https://remoteqth.com/img/wiki-rot-case-5.jpg] ❏ mount rear side of the bottom two screws [https://remoteqth.com/img/wiki-rot-case-6.jpg] ❏ four rubber feet stick [https://remoteqth.com/img/wiki-rot-case-7.jpg] ❏ upper part to ensure the two screws