Local CW keyer for remote keying

This revision is from 2014/04/19 19:00. You can Restore it.

Principle - arduino keyer identifies the played characters (enabled echo feature in K3NG code) and sending to server for playing with other hardware of the cw keyer or cw daemon (contains RemoteQTH server for Raspberry PI). This configuration is resistant to change internet latency during transmission, because not transmitted separately each dit/dash, but the entire ASCII character that perfectly transmiting the server side.

Main functions:

• CW keying
• Detect keying characters and show on the LCD
• Send keying characters to USB serial (echo mode)
• CW sidetone during the PTT is ON, otherwise play audio from RX
• Sidetone volume
• Four SET/MEM switch

← Back to web page

byte cli_paddle_echo = 0;

byte cli_paddle_echo = 1;

SUBSYSTEM=="tty", ATTRS{idVendor}=="0403", ATTRS{idProduct}=="6001", ATTRS{serial}=="A702R984", SYMLINK+="ttyCW0", RUN+="/etc/cw.sh"

#!/bin/bash
# PUBLIC-IP
SERVER=192.168.1.1  # IP YOUR SERVER
CWDPORT=6789
killall socat
sleep 3
socat UDP:$SERVER:$CWDPORT /dev/ttyCW0,raw,echo=0 &
exit 0