Remote multi rotator control

Block diagram

Rack case

• Version 4
• Version 3

Rotators module

• Assemble version 3.1
• Assemble version 3.0
• Assemble version 2.1
• version 2.0
• AC rotator Examples

GPIO interface board

• Assemble version 1.1
• Assemble version 1.0

How to assemble components to complete server

server Configuration

• configure Arduino firmware by K3NG
• custom pins.h
• Enable LCD Display -> (by delete // at the three lines.)

  #define
  FEATURE_LCD_DISPLAY
  #include <LiquidCrystal.h>
  LiquidCrystal lcd(lcd_4_bit_rs_pin, lcd_4_bit_enable_pin, lcd_4_bit_d4_pin,
  lcd_4_bit_d5_pin, lcd_4_bit_d6_pin, lcd_4_bit_d7_pin);

• Change the Baud rate to 9600 (at K3NG source code its 115.k baud the preset)

  #define SERIAL_BAUD_RATE 9600

• install RemoteQTH server on Raspberry PI