Remote multi rotator control

This revision is from 2014/06/15 12:14. You can Restore it.

Block diagram

Rack case

Rotators module

GPIO interface board

How to assemble components to complete server

software Configuration

configure Arduino firmware by K3NG

download stable or unstable and doc
custom pins.h

Enable LCD Display -> (by delete // at the three lines.)

#define FEATURE_LCD_DISPLAY
#include <LiquidCrystal.h>
LiquidCrystal lcd(lcd_4_bit_rs_pin, lcd_4_bit_enable_pin, lcd_4_bit_d4_pin, lcd_4_bit_d5_pin, lcd_4_bit_d6_pin, lcd_4_bit_d7_pin);

Change the Baud rate to 9600 (at K3NG source code its 115.k baud the preset)
```
#define SERIAL_BAUD_RATE 9600
```

install RemoteQTH server on SD card for Raspberry PI

login (yourcall/1234)to web interface and update server from status page
change login and password in menu SETTINGS/LOGIN
in menu SETTINGS/WEB RELAY change name for first relay to POWER and others set to n/a
in menu SETTINGS/ROTATORS set number on Four and configure each rotator

set Name
replug usb and find ID from pop-up window
From/To azimuth without overlap
Get/Set sommand by defaukt
Your locator and apply

For detection USB interface replug all interface by turning power off from the menu CONTROL/SWITCH RELAY - Recognized USB devices shown in STATUS page