RX antenna - K9AY loops switch with FIXED Rload

This revision is from 2019/02/02 21:19. You can Restore it.

Current version 3.1

Assembled KIT

All parts you need - KIT

The drill drawing

Paste the drawing on the box and fix it with some tape.

Schematic diagram

- version 3.1

Insert rest parts

- small yellow Caps 104 = 100nF 3x

- yellow small polyester capacitor 104 1x

- bigger yellow PTC - EX10 1x

- black inductor 1x

- two blue Varistors

- two small resistors 1k

- two LEDs - pay attention to polarity! Long leg is +++

- Rload 2W resistor on the bottom side

chooce the control way...

- By the jumper JP2 you can select controlling over coax or DC voltage on connector X3

TRANSFORMERS winding - very important thing!

    • for 50 ohm coax feed line : 2 turns on primar (coax) and 6 turns on secondar side (loop)
    • for 75 ohm coax feed line : 2 turns on primar (coax) and 5 turns on secondar side (loop)

- In version 2.3 and higher, you can select Coax impedance by jumper JP3.

- Transformer should have 5 + 1 turns.

Common-mode coax choke

- choke measurements

Wind the coax

- Wind the coax as is on the picture, there should be 7 or 8 turns.

- fix it by one binder and use second one to fix choke to the PCB

Solder the coax

KIT - all parts assembled.

Example of controller.

- Injector to coax line:

- direction controller

K9AY loops design example.