Icom CI-V stepper
This revision is from 2019/05/12 21:45. You can Restore it.
Icom CI-V stepper allows tuning with stepper motor Nema 17 some devices dependancy to Icom frequency
Quick start guide
- Connect hardware (Stepper, Endstop switch, Power Supply, TX inhibit output, CAT)
- Configure over USB CLI
Hardware
Connect
Endstop
Stepper
BCD input
CAT
TX Inhibit output
Power supply
USB Command Line Interface (CLI)
Firmware
For upload firmware you have two possibilities
- Download source from GitHub and compile in Arduino IDE
- Download compiled binary from release page and upload with some tool