Icom CI-V stepper

This revision is from 2019/05/12 21:52. You can Restore it.

Icom CI-V stepper allows tuning with stepper motor Nema 17 some devices dependancy to Icom frequency

Quick start guide

  1. Connect hardware (Stepper, Endstop switch, Power Supply, TX inhibit output, CAT)
  2. Configure over USB CLI

Connect

Endstop

Stepper

BCD input

CAT

TX Inhibit output

Power supply

USB Command Line Interface (CLI)

Firmware

For upload firmware you have two possibilities

  1. Download source from GitHub and compile in Arduino IDE
  2. Download compiled binary from release page and upload with some tool
    1. for example avrdude or Xloader for windows

Firmware source

contains some settings which does not available from CLI

  • Time after which reduce stepper current and save last position to eeprom, if disable endstop{long CurrentRunTimeout2 = {0,1000};}