Open interface

This revision is from 2014/08/25 02:36. You can Restore it.

Front side

  • KEYER - CW speed potentiometer.
  • SET - button menu of CW keyer.
  • 1-3 - memory button (hold 1 or 2, switches CW output between CW/PTT 1 and 2).
  • CW - red light LED.
  • PTT - green light LED.
  • FSK - blue light LED.
  • X - green light LED (reserved outputs from Arduino).
  • LCD - shown menu CW keyer and played characters.
  • + - increase transmit audio volume button.
  • - - decrease transmit audio volume button.
  • M - mute transmit audio button.
  • RX audio - receive audio volume potentiometer.

Back side

  • MIC - 3,5mm jack Microphone input.
  • RADIO - DB25 female connector for Radio.
    1. +13,8V (150mA) power input.
    2. CAT CTS.
    3. CAT TXD / Icom CI-V.
    4. not use.
    5. USB D+.
    6. AGNDC.
    7. TX isolated.
    8. PTT1 out (max 50V/400mA).
    9. CW1 out (max 50V/400mA).
    10. FSK out (max 50V/400mA).
    11. MIC input.
    12. TX audio.
    13. RX audio.
    14. Ground.
    15. CAT RTS.
    16. CAT RXD.
    17. USB +5V.
    18. USB D-.
    19. RX isolated.
    20. PTT2 out (max 50V/400mA).
    21. CW2 out (max 50V/400mA).
    22. reserved out (max 50V/400mA).
    23. Foot sw input.
    24. TX audio GND.
    25. RX audio GND.
  • PA PTT - Cinch PA PTT output (max 50V/400mA).
  • USB PC - isolated USB connect to PC.
  • FOOT SWITCH - Cinch foot switch input.
  • PADDLE - 6.3 mm stereo jack CW paddle input.
  • 12V DC - Arduino DC power only - not use.
  • KEYBOARD - USB A female connector for USB keyboard (with Arduino Mega-ADK only)
  • ARDUINO USB - non isolated USB for Arduino firmware upload only.
  • DTR/RTS - DTR/RTS outputs ON/OFF - because the specifications of winkey defines default as ON, you need to have the ability to disable the outputs.

Block diagram

Preset jumper

  • JP2 - switch DTR between FSK or CW outputs.
  • JP1 - switch CAT interface between Icom CI-V and Kenwood/Yaesu UART.
  • JP3 - acess DC to your microphone (short) - suitable for electret microphone.
  • JP3 - Analog ground for codec - default short.

Keyer control

more about firmware and keyer control on author website.

Configure

  • Settings Wintest as winkey (printscreen) 1 2 3 4