Arduino MEGA 63 relay Web switch

This revision is from 2015/10/14 15:26. You can Restore it.

← Web page

Circuit diagram

  • Main board .PDF
  • 16 Relay board (one Bank) .PDF

Running

for to run you need a six component:

  • Arduino mega
  • Arduino Ethernet shield
  • micro SD card, no larger than ??GB
  • Main board
  • Power supply (5V to USB or up to 12V in DC plug)
  • Four relay board controlled by grounded input (Bank0-Bank3) - MAX +50V DC / 500 mA
    • Bank0 16 outputs
    • Bank1 16 outputs
    • Bank2 16 outputs
    • Bank3 15 outputs

Hardware

Compose individual parts

✔ Main board + Ethernet shield + microSD card + Arduino MEGA

✔ How to deploy

Before plug micro SD card, format at FAT16 and upload ascii file config.cfg with this content

[ajaxUrl=http://192.168.1.230]
[deviceIp=192.168.1.230]
[gatewayIp=192.168.1.1]
[title=DM5XX web realy]
[jsUrl=http://remoteqth.com/dm5xx-web-relay.js]
[cssUrl=http://remoteqth.com/dm5xx-web-relay.css]
[faviconUrl=http://remoteqth.com/favicon.ico]
[dotUrl=http://remoteqth.com/dm5xx-web-relay-dot.png]
you must configure the first three lines (IP addresses), in accordance with the settings in the Arduino firmware

❏ microSD plug to Ethernet shield and deployed to Arduino MEGA

❏ then connect to Main board

Configure jumper

  • JP1 - short disable auto reset from USB (must be open at upload firmware)
  • JP2 - short connect power between Arduino DC input and power on Relay board - WARNING to maximum voltage Arduino Mega

How to connect own relay

Firmware

  • For beginners Getting Started with Arduino
  • You can configure firmware from master tree GitHub
    • Or download preconfigured version
    • 2015-10-14.zip
    • config.cfg edited and copy to microSD card and plug to Ethernet shield
  • Download Arduino IDE
    • open.ino file, compile and upload to Arduino MEGA

Configure firmware

  • Network in section
    byte mac[] = { 0xDE, 0xAD, 0xBE, 0xEF, 0xFE, 0xED };  
byte ip[] = { 192, 168, 1, 230 };                      
byte gateway[] = { 192, 168, 1, 1 };                   
byte subnet[] = { 255, 255, 255, 0 };