IP Remote hardware Switch

This revision is from 2015/12/26 23:58. You can Restore it.

← Web page

The hardware

Relay front side

  • 1-16 - green LED signalized switched relay.
  • white square - sign defines the type of equipment.

Relay back side

  • DATA - not used.
  • USB - +5V DC POWER supply, or upload arduino firmware (needs open jumper JP5).
  • ETHERNET - RJ45 LAN connector.
  • OUTPUTS - 14 relay outputs and GND

Control switch

  • 1-11 - rotary switch.
  • 12-15 - four rock switch with LED.
  • 16 - pushbutton.
  • LINKED - green LED signalized:
    • connect with relay board over IP LAN
    • latency (delay) same as LED OFF time.

How to connect

  1. connect LAN UTP cable direct or via switch (configure connect via internet in a separate chapter)
  2. plug power via usb mini cable to AC adapter, computer or usb HUB