IP Switch with ESP32-GATEWAY

This revision is from 2017/12/09 12:59. You can Restore it.

This kit worked with ESP32-GATEWAY Ethernet/WiFi module from OLIMEX. Below step by step assembled manual for 16 outputs (two boards).

Assembled

❏ Solder 2x12 1k rezistors R1-R14

❏ 2x10 100n capacitors C19-C35

❏ 2x8 LED diodes D38-D45

❏ One BCD ID switch P6 on LEFT board

❏ One female pin header P5 on LEFT board

❏ One male pin header P4 on RIGHT board

❏ 2x 74HC595 IO U8

❏ 2x DIP socket for U5

❏ 2x male 2x3 pin header P2

❏ 2x male 2x7 pin header P3

❏ One DC jack J1 on LEFT board

❏ One male 1x20 pin header P1 on LEFT board

❏ Put output driver to DIP socket by your preferency

ULN chip for switching by output collector (grounding) need use two Jumpers on left P2 pin strip
UDN chip for switching by output emitter (voltage from P3 Vin) need use two Jumpers on right P2 pin strip

❏ One femmale 1x20 pin header CON1 on TOP side OLIMEX ESP32-GATEWAY