TX antenna - 2EL antenna array 4 direction

This revision is from 2018/06/09 15:46. You can Restore it.

<<- Web page

This is TX-RX antenna mainly for lower bands. It is based on classic 4SQ with 90deg phase hybrid.

Quick Start Guide

Connector description

  • There is standart RJ45 (ETHERNET) connector with shielding

  • There is standart D-SUB 15 female connector with shielding

  • Table

  • Connectors on Hybrid PCB:
    • detector = dummy load power
    • 1 = DIR1 , 2 = DIR2

SWR LED bar settings

  • ⚠ NOTE: Input SWR of the hybrid is not SWR of the antenna!!!
  • SWR Range trimmer - Range of PWR in dummy load

Setting step by step

    • Connect TRX (PA) to the 2EL hybrid - to Input port
    • Connect Dummy load to the Dummy Load port ( you can insert PWR meter too )
    • DO NOT connect any antenna element - leave it open
    • Switch direction on controller to WEST or EAST
    • Than when you TX (RTTY mode) all power goes to the dummy load port
    • Open controller box
    • There is SET SWR trimmer (blue one)
    • With this trimmer you can set full range of LED bar for prefered MAX power in dummy load

⚠ NOTE: Do not forget thar SWR 2:1 on antenna elements is 1/10 of INPUT power to dummy load!! So for 1kW and SWR 2:1 is 100W in DL. There is no problem to have only a few Watts in DL when the antenna elements are right tuned!

    • So set TRX power to your max PWR you want have in dummy load and set SET SWR trimmer to full LED bar range
    • When LAST red LED is on, than PTT loop is disconnected * see jumpers setting

⚠ NOTE: When you set full scale for some PWR, for example 200W. Than you can go down with PWR from your TRX and you can see what PWR = LED COUNT. What is half of scale, first LED etc.

Jumpers setting

  • When power in dummy load exceeds value you you set before, than protection circuit breaks PTT loop and Buzzer sound is ON.
  • Jumpers:
    • JP1 = ALARM - switch ON/OFF buzzer and PTT LOOP break
    • JP2 = LED BAR mode (dot/line)

- Return loss (RL) in dB to SWR:

ONLINE calculator RL to SWR

ToDo

  • Cable wiring circuits