K9AY feeder with BPF

This revision is from 2018/06/28 19:58. You can Restore it.

<<- Web page

This is plastic box with the aluminium holder. Inside it, there is transformer with insulated windings, variable Rload, input and output protections. and in the middle, 160/80/40m BPF or bypass and 15dB preamp.

All you need is connect loops' wires, GND, coax cable and control cable (CAT-5 UTP or better FTP)

Connector description

  • There is standart RJ45 (ETHERNET) connector with shielding

  • Connector PIN description:

  • direction logic ( apply +12V for logic 1 )

Rload: FIXed or VARiable

  • With Jumper JP2 you can switch between FIXed or VARiable Rload.
  • If you short 1 and 2 than there is abt 450 Ohm fixed Rload. If you use controller with Rload controller, than switch to last position 9

Rload - checking the resistance

  • Connect Ohm meter to this position and measure value vs input Rload VTL voltage - PIN 6 on RJ45 connector

Preamp BIAS - SET/check current and voltage

  • Connect Volt-meter to GND and jumper JP1. Measure voltage ( PREAMP ON ), it should be more than 11V. ( if you want HIGHer IP3, than it could be 15V / 80mA :) )
  • DISconnect jumper JP1 and connect mA meter on the pins ( 200mA scale is fine ). Turn with R4 multi-turn trimmer and set bias to 65 - 85mA. You can have a look at my measurements: 2N5109 OIP3 vs voltage and bias

ToDo

  • Cable wiring circuits