Web relay

This revision is from 2013/12/22 20:50. You can Restore it.

This set only name (or note) for each relay seperatly. Name will be show in controll section. If set name as n/a, this relay is not shown in control section.

Realy name name each relay
Save relay settings restore the current settings after reboot (available DISABLE or RESTORE). If enable, this setting shown in controll page.

Relay installation

Relays board connec to GPIO port on Raspberry Pi used 4, 17, 18, 21(27), 22, 23, 24, 25 (from 1 to 8) GPIO outputs.

source

n2n VPN << Prev | Next >> Sensors