Remote multi rotator control

This revision is from 2014/10/05 01:17. You can Restore it.

Block diagram

Rack case

GPIO board for model B2+

How to assemble components to complete server

software Configuration

  • configure from master tree Arduino firmware by K3NG, or download preconfigured version
  • install RemoteQTH server on SD card for Raspberry PI
    • login (yourcall/1234)to web interface and update server from status page
    • change login and password in menu SETTINGS/LOGIN
    • in menu SETTINGS/WEB RELAY change name for first relay to POWER and others set to n/a
    • in menu SETTINGS/ROTATORS set number on Four and configure each rotator
      • set Name
      • replug usb and find ID from pop-up window
      • From/To azimuth without overlap
      • Get/Set sommand by defaukt
      • Your locator and apply
    • For detection USB interface replug all interface by turning power off from the menu CONTROL/SWITCH RELAY - Recognized USB devices shown in STATUS page as rot1 , rot2, rot3 and rot4